Why we use parllel operation of alternator



Why we use parllel operation of alternator..

Answer / sharath

to share the load in the power system

Is This Answer Correct ?    5 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

i asked a funny question in Electrical ohms law V=IR in const temp voltage is directly proportional to current Power p=VI cos@ in that formula Voltage is indirectly proportional to current Try to give me the fact what is happening in Electrical.. contact Thanigai_1984@yahoo.co.in

3 Answers  


please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula

1 Answers   Foxconn,


In Ferranti effect,Receiving end voltage is greater than sending voltage,why? can anybody tell me the answer

15 Answers   Engineers India Limited,


If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables

1 Answers   ABC,


how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???

1 Answers  


How much load can take a 16 mm aluminum cable 3 phase

1 Answers   L&T, Sanga Energy,


What is the meaning, function and application of OLTC?

3 Answers   Home,


How to apply 'c' license and also explain what is difference between 'c' and 'b'license.i am also working in one of the private company.i have finished my diploma in 2014 .i have already finished in ITI electrician course.....

1 Answers  


Why VCB and SF6 breakers to be used in HT used by cant ACB of higher rating to be used for 11kv and 33kv.

8 Answers   TCS,


We have 420volts, Diesel gen-sets each 750kva 4nos. we are operating with bus bar duct having 10x150mm for each face 4nos. our question is what is the minimum gap required between each face? is there any satutory regulations?

1 Answers   Alliance One,


what is the last range of mccb in amp?

2 Answers  


dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)