Answer / arjun

2/100*16=.32ma

Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =

0 Answers  

---

How LVDT position transmitter works on DC supply(24vdc) from DCS, whereas transformer operates on AC supply? pls help..

1 Answers  

---

Witch type cable use for rtd ,why?

2 Answers   Sugar Factory,

---

i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....

0 Answers  

---

How to calibrate Magnetic flow Transmitter in Field

0 Answers  

---

How to carry out hot loop checking of closed loop pf temperature control valve & temperature transmitter?

2 Answers  

---

How will you change the action of a control valve?

1 Answers   CCIE,

---

Why the tapping connections are taking above for gas service and below for liquid service?

2 Answers   ADCO,

---

give me all the details about the interview and which type of question being asked

0 Answers   Jindal,

---

A differential pressure transmitter is configured to measure the height of an open tank : height 10m and dia 5m. Suppose this same transmitter is shifted to another open tank : height 10m and dia 4m. What will be the %error in measurement? how?

3 Answers   McCoy Engineering,

---

Isometric drawings are generated during _________________ phase of a project

0 Answers  

---

Can we use twisted pair cable instead of ethernet for communication?

1 Answers   Yokogawa,

---