Answer / aissa

why we use sensing type(NPN)on a vibration monitring
system not a (PNP)sensing type
ANSWER
it's a matter of THE COST since NPN technology is less than PNP

What is the difference between Analytical instruments and other instruments?

7 Answers   Schenck,

---

any one suggest me how to calculate percentage of air leakage with formula,

0 Answers   SSL,

---

why using 4-20ma not using 0-20or why not using 1- 20ma???????

7 Answers  

---

What is rated capacity in Control valve

3 Answers  

---

Can we place a Control Panel in Hazardous area Group IIC ? If 'yes' then is there any approval required? If 'yes' then there is any specific IP rating or any standard required? If 'Yes' What is MOC of control panel?

2 Answers  

---

How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible

1 Answers  

---

WHAT IS A SYMPTOM OF FAULT WITH THE SPAN OF AN INSTRUMENT? 1)ZERO-POINT AND 100% ARE CORRECT BUT NOT A MID-RANGE. 2)ZERO-POINT IS CORRECT ,BUT 1005 INPUT IS NOT GIVING 100% OUTPUT. 3)LINEARITY PRBS. 4)1005 O/p IS CORRECT BUT ZEO POINT IS WRONG.

1 Answers   Reliance,

---

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

0 Answers   Hospira,

---

In which principle Woodward Governor 505 work in power plant? What are the input of Woodward governor 505

1 Answers  

---

what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...

2 Answers  

---

What is the use of valve positioner?

1 Answers   CCIE,

---

pressure gauge measure static pressure or dynamic pressure?

3 Answers  

---