Answer / himansu sekhar pradhan

Take some motar sample of plastering then poured into a
measuring jar. Then add sufficient water and sake
vigorously then kept cylinder on a non vrabating place for
minimum two hours. Then calculate the ratio of volume of
fine cement layer at top and sand layer at bottom.

Answer / biplab

At first you take some quantity of plaster, let 1cu.m
then the wet volume of plastering is=1 x 1.33 cu.m
and then this quantity divided by sup of ratio suppose the
ratio is 1:6
ten the quantity of cement is= 1.33/7=0.190 cu.m=5.43 Bags
quantity of sand is =(1.33/7)*6=1.14 cu.m

if we know load bearing capacity of the soil and building load falling in each footing, then how to choose the type of foundation??? and if it is shallow foundation then which type of shallow foundation should be choosen i.e either strip or isolated or raft or combined or cantilever footing???????

0 Answers  

---

what will be the difference in compressive test results for a 150 mm cube, a 150 mm cylinder and a 300 mm cube

5 Answers  

---

How may digree of freedon in four bar chain.

1 Answers  

---

formula of calculation of weight of steel bars

15 Answers  

---

List out some of the software program that can be useful for architect?

0 Answers  

---

what is difference between active and passive earth pressure. how it effect the retaining wall design ?

4 Answers  

---

What is Aggrgate sizes used in a WMM Plant?

3 Answers   Black Stone,

---

What is difference between FSI & FAR,

2 Answers   Ritechoice, Sukhwani Constructions, Tejas,

---

1:6 brick masonry cement and sand calculations

2 Answers   NCC,

---

difference between limit state method and working stress in terms of load

6 Answers   CCCL,

---

what is the grade of lean concrete?

3 Answers  

---

how you confirm the hard stratum for driven cat in situ pile work?

2 Answers  

---