Answer / Awdhesh Kumar Gautam

Site acceptance tests for these electrical equipment typically include functional testing, load testing, voltage drop testing, insulation resistance testing, earth continuity testing, and harmonic distortion testing. The specific tests may vary depending on the manufacturer's instructions and local regulatory requirements.

why we use to always generate power below 16kv.why not at higher voltage?

3 Answers  

---

What is VCB? Where it is installed?

11 Answers   Hyundai,

---

why doesnt the back emf hold the speed of unloaded series motor?

1 Answers  

---

what is the difference between contactors & relay.

2 Answers  

---

what are adantages of OC and SC test over the load test?

5 Answers  

---

what is p.s impedance measurement test in earthing transformer?

1 Answers   Greenko,

---

how will we calculate the copper wire load..

1 Answers  

---

how to calculate ups and battery rating

2 Answers  

---

for testing busbar (33kv) hi-pot .whether we can apply DC r not.and what is the test volt for that .explain

4 Answers   WGPSN,

---

Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????

1 Answers  

---

why we r used APFC Panel in industrial area.when P.F. low then wat will be the effect in our system?

10 Answers   ABB, Georgio Rocks, Piramal Healthcare, Zenith Engineering Corporation,

---

What are the safeties in elevators?what is the use of governor in elevator?

3 Answers   JLL,

---