For the purpose of inflating car tyres, spray painting,
etc. i.e. say a small workshop, what size of a compressor
(CFM) is recommended? It will be generally for a hobby use
and not commercial use.
- 1 Answers
- 3370 Views
- I also Faced
- E-Mail Answers
Answer Posted / manjunath
spray painting it is generally used for painting in a very
smaller areas of any part and where it is very hard to paint
in a brush .... And to improve faster rate of painting,,
spray painting r used........usually reciprocating
compressor r used but size depends upon requirement...........
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the Diesel consumption of 1000 KVA rating DG set at full load?
If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above
What is CX and DX mean or abbreviation for JCB Backhoe Loaders ? I know they are models 3CX is used in Europe and 3DX is used in India but I am looking for the full form of those abbreviations - Thanks
Will engine performance be damaged by mixing oil in fuel of four stroke bike ?
What is the difference between bs2 & bs3 engine?
What is Brinell's hardness test ?
The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft
What are three methods of heat transfer?
Hard shifting of gears would result when a) There is rapid engagement of gears b) There is less heat dissipation c) The clutch inertia is very high d) There is no clutch free pedal play
The friction plate is always mounted on a) flywheel b) Pressure plate c) Internally splined hub d) Clutch spring
Why oil with petrol can be used in two stroke engines but not in four stroke engines (two wheelers)?
how to calculate 500 k.v.a diesel generator efficiency
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
What is bhp? How can you measure bhp?
What happens if you use petrol in diesel engine?
