What happens if gasoline is used in a diesel engine?
Diesel engine will work ?
Answers were Sorted based on User's Feedback
Answer / jay kumar
no it will not work,as the compression ratio of petrol engine is 6 to 10 & that of diesel engine is 15 to 22.Thus on such high compression,gasoline gets highly compressed & it may blast.
| Is This Answer Correct ? | 11 Yes | 1 No |
Answer / rpsingh
petrol engine will get blast and diesel engine will not work
| Is This Answer Correct ? | 4 Yes | 4 No |
Answer / ravikumar
Compression ratio for diesel engine is 14 and for petrol engine is 8. When petrol is used in diesel engine, during initial part of compression during cranking it reaches the combustion temp. burns and pushes the piston down _ reverse firing. When diesel is used in petrol engine it will not reach the required compression ratio and it will not burn.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / vishal patil
If petrol in diesel engine then it will work but knocking issue occur and early ignition of petrol will take place since cr of diesel engine is high and also diesel act as a lubricator in fuel line there may be chance of damage of fuel line
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / yes the diesel engine will wor
yes the diesel engine will work, the problem will be
complete lack of power and throttle response.
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / abhishek vyas
Work? It will blast like a bomb. petrol work on compression
ration 9 and diesel on 18. now think what happen if we
compress petrol to this much pressure.
| Is This Answer Correct ? | 4 Yes | 6 No |
what happen when there is moisture in the TX valve?rac
What is the mathed of maintain oxizen level in a air tite A/c room.
How to convert GSS duct volume in KG for all guages
How do motion detectors work?
What is the b check value of a 4bt engine
I'm a Entrepreneur, now I'm seeking a job in the same domain in an Engineering company.I'm planning to leave my business to my Brother.How can I positively explain my sitivation in an interview to impress my employer. Pls advise
function of waterpump
how to handle manpower in production department ?
What would be the COP of a chiller having capacity of 750 TR and IKW is 0.6 KW/TR
we need tech specs of HP fan cap 50,000 m3/Hr, Pressure o.5-0.7 Bar for blast furnace at steel plant
0 Answers Despro Technologies,
What will you check if one cylinder of your engine is not like the others?
can a deareator be placed at any height with care that suction (NPSH) for feed pump is satisfied
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)