If I have a motor of 1MW with 6.6kv, running at 35% load, how
can i save energy without reducing the load ?
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
With capacitor you can reduce line losses but it better to
replace the motor with one of required capacity.
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / o.suribabu
WHY CAN T WE GO FOR VFD ;IF CAPACITY IS REQD IN FUTURE U CAN
HAVE A CHOICE TOO
| Is This Answer Correct ? | 1 Yes | 1 No |
What is the difference between induction motor and the Synchronized one?
what composit error,ratio error,phase error in CT and PT??
working principle of current sensing relay? how its work?
what is residual current....
Suppose an electric motor with a controller is not working. What is the sequence of testing you will do in your troubleshooting?
How to know the back up time for a 5KVA UPS which is connected to 15 nos. of computers? Is there any formula for this? pls. tell me.
which one cable has a more resistance.A big or small
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
why do we need a 4th wire in 3phase 3wire transmission line
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
a solar energy installation utilizes a three phase bridge converter to feed energy into power system through a transformer of 400v/400v.the energy is collected in a bank of 400v battery and is connected to converter through a large filter choke of resistance 10ohms.1.the maximum current through the battrey will be.2.the kva rating of the input transformer is.
what is the difference between dropout fuse and horn gap fuse. how to choose between them
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)