Which one is more accurate servo or stepper motor and why?

Question Posted / nigamsingh_85

2 Answers
7494 Views
BARC, HPT, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Which one is more accurate servo or stepper motor and why?..

Answer / shyamkr

stepper motor is more accurate because its rotation angle is
fixed for each elctrical signal.
whereas in servo motor this rotation is not precise as
compared to stepper motor.

Is This Answer Correct ?

13 Yes

3 No

Which one is more accurate servo or stepper motor and why?..

Answer / bertrand

Servo motor use analog or (better) numeric signal
processing in order to make the motor exactly the desired
position. The theorical accuracy limit is only the encoder
resolution and the friction of the gearing which exhibit a
non linear behaviour, difficult to be modeled. Currently,
stepper motors are a bit obsolete, survivors of a time
where signal processing was uncommon.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How we calculate the spacing between the conductors in 11,33KV lines?

3 Answers NHPC,

In a company the lines carrying 33KV but the load is below 10000Volts so we know that <11KV we can put 11KV lines but the lines are 33KV,..so how we can step down the voltage to 11KV with out erecting a substation

1 Answers

what is the purpose of shading ring or shading coil in electrical equipments.

0 Answers BARC,

Why is the electric shock from the DC supply is more dangerous than the shock from AC supply.

8 Answers IBM,

Phase control and integral control are used for?

0 Answers NPCIL,

ELCBs are installed for protecting humans from AC leakage current.Is there a device which protects humans from DC Leakage current??e.g.leakage from batteries...If not,then why so???

1 Answers

what is power factor? is it good or bad for a system? what will happen if power factor increase or decrease?

4 Answers Bhel,

what is the working principle of soft-starter & how it diff. from VFD ?????????

5 Answers L&T,

What is core balancing in Power Transformer. What is the affect of an unbalabce core.

1 Answers

DG use Rating KVA why

1 Answers

What is the cause for a blown fuse in one phase of primery side(HV) of a three phase transformer( 4169v-460v) in the time of closing its supply breaker. There is no load on the secondery side of the transformer in this moment.

3 Answers Novachem,

why d.c motor speed decress with increass in load?

1 Answers

For more Electrical Engineering Interview Questions Click Here