Answer / sundarrajan

balanced network means system consist of feedback and hence
it is called closed loop system.
unbalanced means system consist of no feedback and hence
the system is open loop system.

what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?

0 Answers   Finolex,

---

how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.

0 Answers   OPS,

---

How Much Capacity of Diesel Genset is suitable for 20 no.s of 1.5ton AC's & Why?(Load Calculation)

11 Answers   Lapis Technologies,

---

What are the different types of testing in ht cables?

3 Answers  

---

In CTs tan delta point should be earthed , what is the reason behind it?

0 Answers  

---

defination of loads

1 Answers  

---

what is the difference between ceiling fan and wall mounteed fan technically

3 Answers  

---

why we use salt for earthing?

1 Answers  

---

A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.

0 Answers  

---

what is alternator?

4 Answers  

---

1 KVAR = 1.3Amps but, 25KVAR capacitor/690V capacitor takes just 21Amps as leading current, what is the reason? Please explain...

1 Answers  

---

why our power production in multiples of 11.

2 Answers   ABB, Infosys,

---