Answer / md. ismail hossain

Fusing factor is ratio of minimum fusing current to the
current rating of the fuse element.

Fusing Factor = minimum fusing current / current rating of fuse

.............By V.K MEHTA

Answer / rutu chitroda

it's value should be always greater den 1....and due to any atmospheric effect the fusing element should no get melt.....so it is important to decide fusing factor

Answer / sweetu

fusing factor is define as the ratio of minimum fusing currnt to rating of the fuse. we can say that is is the factor which add as error

Answer / prashant

it is a minimum current that fuse can sustain

How much energy save vfd if motor run on 50 Hz (full speed)

3 Answers   Reliance,

---

what is gapless metal oxide techniques?

1 Answers  

---

Why the output of generator varies eventhough the shaft speed is constant in thermal power plant?

5 Answers  

---

One of the advantages of HRC fuse links is that they can be used to back up equipment with an inadequate rupture rating. briefly discuss what this means

1 Answers  

---

which connection is there in a rotor of the motor

2 Answers   All Trades Electrical, HAL,

---

what is the maximum genarating voltage in india?

32 Answers  

---

A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.

0 Answers  

---

If in a 3 phase supply if the load current is 200A what value of current the each phase R,Y & B will carry?

5 Answers  

---

When the DG is running at the time we can connect to capacitor banK? why it is required or not

1 Answers  

---

is there any pottential in neautral?

3 Answers  

---

What will happen if we give 220v supply on both sides to the bulb

7 Answers   Exide, Sumeet Industries, Toshiba,

---

in star delta starter current is 1/3times the delta value how?

2 Answers  

---