What is the difference between coagulation and flocculation
in water treatment plant?



What is the difference between coagulation and flocculation in water treatment plant?..

Answer / yemmadi

flocculation means rising of small particles with bubbles so that we can easily remove them

Is This Answer Correct ?    7 Yes 3 No

Post New Answer

More Chemical Engineering Interview Questions

What is the significance of the minimum flow required by a pump?

0 Answers  


What is an effective means of removing silicone from aluminum?

0 Answers  


What are the design considerations for a piping system for the transfer of slurries?

0 Answers  


What are some good estimates for heat transfer coefficients for coils in tanks?

0 Answers  


How can you prevent bridging in a dilute phase pneumatic conveying system?

0 Answers  






how can i prepare for gate chemical in kolkata

0 Answers  


How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?

0 Answers  


Question 89 - A hemocytometer is a device that is used for counting cells. In an engineering experiment, 100 microlitres of cell suspension is diluted with 50 microlitres of Trypan blue dye. Only death cells appear blue in color when stained with the dye. There are 57 cells detected in a hemocytometer, where 5.3 % of them appear blue when the chamber of the meter is placed under a microscope. Each square of a chamber can contain 0.0001 mL of liquid. (a) Calculate the number of viable cells. (b) The cells ocupied 5 squares. Calculate the average number of viable cells / square. (c) Calculate the dilution factor of the cell suspension by using the formula : Dilution = final volume / initial volume. (d) Calculate the concentration of viable cells / mL by using the formula : Concentration = (Average number of viable cells / square) x dilution x (square / volume).

1 Answers  


Define octane number?

0 Answers  


BIOPROCESS ENGINEERING - EXAMPLE 14.3 : The kinetic behavior of an enzyme could be described using Michalis - Menten equation : Vo = Vmax [S] / (Km + [S]). Derive this equation from [ES] = [E]total [S] / (Km + [S]), Vmax = Kcat [E]total, Vo = Kcat [ES].

1 Answers  


What is Vacuum? If pressure is less than that of atmospheric, can we call it vacuum? If so some places have less atmospheric pressures, can we call people living there are living in vacuum?

5 Answers   ISRO, TCS,


What are the some common problems associated with dense phase pneumatic conveying?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)