how did you spend today

0 Answers  

---

According to Shockley equation, the I – V characteristic of a diode is approximated by I = IS [ exp (nVD / VT) – 1 ]. For silicon, let the reverse bias saturation current IS as 0.000000000001. If n is ideality factor with value of 1.5, VT as thermal voltage drop of 0.026 V at room temperature, what is the value of current I that passes through the silicon diode in the heater of evaporator when the forward voltage drop VD = 0.026 V? Please take note that exp is the exponential function with e(1) = 2.718, e(2) = 7.389.

1 Answers  

---

is extractive distillationӞH

0 Answers  

---

Question 29 – For a Vernier scale that consists of 0.11 cm per section, estimate the length on actual standard ruler of 0.1 cm per section for 2.39 m and 0.91 m.

1 Answers  

---

What diffrence between flush distillation & batch distillation ?

0 Answers  

---

significance of fouling factor in shell and tube heat exchnager

1 Answers  

---

need the type of technical questions in written test

0 Answers  

---

Question 49 - According to rules of thumb in chemical process design, consider the use of an expander for reducing the pressure of a gas when more than 20 horsepowers can be recovered. The theoretical adiabatic horsepower (THp) for expanding a gas could be estimated from the equation : THp = Q [ Ti / (8130a) ] [ 1 - (Po / Pi) ^ a ] where 3 ^ 3 is 3 power 3 or 27, Q is volumetric flowrate in standard cubic feet per minute, Ti is inlet temperature in degree Rankine, a = (k - 1) / k where k = Cp / Cv, Po and Pi are reference and systemic pressures respectively. (a) Assume Cp / Cv = 1.4, Po = 14.7 psia, (temperature in degree Rankine) = [ (temperature in degree Celsius) + 273.15 ] (9 / 5), nitrogen gas at Pi = 90 psia and 25 degree Celsius flowing at Q = 230 standard cubic feet per minute is to be vented to the atmosphere. According to rules of thumb, should an expander or a valve be used? (b) Find the outlet temperature To by using the equation To = Ti (Po / Pi) ^ a.

1 Answers  

---

How can we identify a poisoned food if we are not able to sense it?? . .,(naturally by colour ,smell etc. . .)

1 Answers  

---

Why is post-weld heat treatment (stress relieving) sometimes necessary for welded vessels?

0 Answers  

---

Name some common causes of control valve noise?

0 Answers  

---

why 14.7 pound/inch2 is used in idustries as unit of pressure bcz here not sea level and not a temperature is 0C (zero degree celcius)?????????

0 Answers  

---