What happen if 200KVAR capacitor continuesly connected to load and all the pla

What happen if 200KVAR capacitor continuesly connected to
load and all the plant machinaries are not in working?

Question Posted / anant himandi

4 Answers
6635 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What happen if 200KVAR capacitor continuesly connected to load and all the plant machinaries are n..

the power factor of the system would be leading. IT also has
a tendency to increase the voltage slightly.Other wise no
harm happens except you are helping the power suppliers
maintain the PF in their system at your cost.

Is This Answer Correct ?

6 Yes

0 No

What happen if 200KVAR capacitor continuesly connected to load and all the plant machinaries are n..

Answer / srikanth

to reduce angle between voltage and current we use kvar
capacitors.. if it placed contiously the voltage will get
lead than current,it increases voltage and reduces current
during that no current the machines will not work... may
aslo get damage to the mahines....

Is This Answer Correct ?

2 Yes

0 No

What happen if 200KVAR capacitor continuesly connected to load and all the plant machinaries are n..

Answer / rk gupta

If capacitor is permanently connected to off machinery load then voltage will lead than current. then other equipment's might be damaged due to increasing of voltage.

Is This Answer Correct ?

0 Yes

0 No

What happen if 200KVAR capacitor continuesly connected to load and all the plant machinaries are n..

Answer / abhijeet

It Will Occurring Ferranti Effect ...

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what is thermal setting and magnetical setting?

1 Answers

what happen if one of 3-phase line has a much higher load when we are using delta to star transformer? how we can over-come from that?

2 Answers Getco,

HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?

0 Answers Eastern Produce,

what will happen if phases are not shorted with neutral in transformer impedance test? and if neutral is not connected with ground?

1 Answers

what is the effect come when i changed the alternator exciter field winding DC palority(+ve & -ve)which is coming from AVR.

1 Answers Wartsila,

why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?

0 Answers

hi frienda We have 750kva cater pillet dg set we are fasing one diffrent proublam in dg we are start dg set after one mint applying load around 450a load but dg was run 3 Or 4 mints after 3 mints dg was shuding down automatic how to face this proublam pls tel any budy

1 Answers

when the direction of a 3phase induction motor is reversed , is there any losses increases?

5 Answers IOCL,

show me the diagram of three phase wiring and also tell me hoe to take the readings of megger testing

2 Answers

we have one pumping station and 4.6 MW 7 no.s synchronous motors.so there is no required HT capacitor to improve power factor.But we have two no.s of 25 Mva power transformer connect to distribute the power for motors connect with 220 kv line.So i have required the HT capacitor to improve power factor at HT side i mean power transformer bus side.So please suggest how much HT capacitor banks required for same.

1 Answers

why we use shunt in a rectifier system ?

1 Answers

71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit

0 Answers Machino,

For more Electrical Engineering Interview Questions Click Here