whay we used silica gel in Transformer

Question Posted / thanigai1984

3 Answers
8156 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

whay we used silica gel in Transformer..

Answer / girish vania

Silicagel is used in transformer to restrict the entry of
moisture particle in side the tank. When the oil is been
heated inside then the warm air goes out from ventilation
plug at the same time fresh air has to enter inside to
fulfill the vacume. This fresh air goes to silicagel
breather where moisture particle is been adopted by
silicagel.

Is This Answer Correct ?

35 Yes

1 No

whay we used silica gel in Transformer..

Answer / dheeraj sharma

yes silica gel is used in transformer for absorved the
moisture from the air.

Is This Answer Correct ?

13 Yes

3 No

whay we used silica gel in Transformer..

Answer / ashok mishra

it absorbs all the moiosture content of the air and send dry air inside the transformer

Is This Answer Correct ?

5 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Short circuit current of 2500 KVA 11/0.415 KV transformer both Secondary and primary side. best regards. Ali

1 Answers

How to calculate wire length,size & current? ( related to control panel)

0 Answers FSS, GK Controls, Panel Tech,

WHAT IS A DIFFERENCE BETWEEN A DC GEAR MOTOR AND STEPPER MOTOR.AND WHICH IS MORE APPROPRIATE TO USE FOR POSITION CONTROL PURPOSE?

1 Answers

If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?

0 Answers

my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers

why Ac current is alternating in nature?(or)why alternating current changes its direction?

3 Answers APGenco,

what is the differebt between ac and dc fuse?

0 Answers IBM,

i need to connect fact device(any one from following upsc,sssc,svc,statcom and tcsc)in 14 bus system....by using MATLAB psat software....if i connect these fact devices,i will get some error as "virtual error"...i cnt rectify this error.if anybody know that how to work in psat,pls help me to rectify this error.... or send mail me to, viki0607@yahoo.co.in

1 Answers

Why does the DC voltage needed is less than AC needed to produce corona?

2 Answers TATA,

Supose we have one 220v A.C fan.if we provide 220v D.C what will be happen?

13 Answers

Explain what is Zener diode?

1 Answers

What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!

0 Answers Bhel,

For more Electrical Engineering Interview Questions Click Here