Answer / bishnu charan das

Because plant and machineries are having inductve loads
like motors,Transformers etc whch are having low lagging
power factor.To reducing the loss due to low power factor
we have to improve the power factor.So we are installing
the capacitor bank for maintaining the KVAR value.

Why using synchronising methed in DG's sets?

0 Answers   Juniper Networks,

---

what is necessity of using isolation transformer?

4 Answers   NTPC,

---

What is the approximate percentage of Si content in transformer core(CRGO-Cold Rolled Grain Oriented)? Why it is kept so low?

1 Answers  

---

solor panels arrange some angle,panel is flat fitted energy was produced or not why?

0 Answers  

---

Terminal blocks is used for segregate the connections... There is any principle for terminal block..?

0 Answers  

---

If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?

0 Answers  

---

Capacitors are used to ... -Reduce the bill of the farmer -Improve the PF

1 Answers  

---

The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is

0 Answers   Caterpillar,

---

If we connect capacitor in series DC supply so what happened?

4 Answers  

---

how to write program by ladder logic in case of PLC operation

3 Answers   Gridco, Sofcon,

---

how much flux density of CRNO core

0 Answers  

---

draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it

0 Answers  

---