Answer / a.p.nanjappa

No.it is done for building campus,
industries,hospitals.large campuses, tv station...

It depends on load,voltage level of source and distribution
sytem.


refer IEEE 80 hand book

wht do u mean by load in circuit.wht dp u mean by inductive load

7 Answers   SGS,

---

What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?

1 Answers   K-Electric Limited,

---

I need HT sphere gap calibration table. Can any body help me.

1 Answers  

---

what is alternater?

8 Answers  

---

if we know Fault level say 25 KA , How to decide busbar size for Distribution network of 1000 Amp Breaker ? Sample Calculation or Farmula Available or not ?

4 Answers   TCS,

---

How much width of the land shall have to be left below the EHT line of 440 kv as per the rule. i am told that a corridor of 35 M width is to be left free below 220 kv line. please confirm

1 Answers  

---

How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.

1 Answers   ABB,

---

i want to estabilish an loss energy storage system,such that it can store electricity lost during the transmission of electricity in conductor,so that this system stores energy lost during transmission and supply it to street lights during night

2 Answers  

---

If short circuit ratio is high is it bad or good for a machine then tell the reason...

1 Answers   Bhel,

---

how ct burden,magnetising current,ratio and knee point voltage are related & derived

1 Answers   Dalkia, SCT,

---

The unit of resistivity is:(a) ohms(b) ohm millimetre(c) ohm metre(d) ohm/metre

4 Answers  

---

How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.

1 Answers   Allied Group,

---