How are calculate the Speedometer ratio in the vehicle?
No Answer is Posted For this Question
Be the First to Post Answer
The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
Why rear wheels are bigger in vehicles?
face to face first interview for the post of service engineer to question
0 Answers Ashok Leyland, TATA,
The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
where is fan located in car?before radiator or between engine and radiator?
The number of arms provided to the Cross of the Hook's joint is a) 1 b) 2 c) 3 d) 4
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is CX and DX mean or abbreviation for JCB Backhoe Loaders ? I know they are models 3CX is used in Europe and 3DX is used in India but I am looking for the full form of those abbreviations - Thanks
What do you understand by Newtonian Fluid? Where is it used?
I have a 2000 grand Prix with the 3.8 liter engine and my alternator went out are there other alternators that can be used instead of buying the specific one needed.
How fuel tank capacity is decided for any two wheeler or four wheeler ???
Explain the Otto cycle.
Types of Injection system in cars?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)