which relay is used on long transmission lines
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
mho relay is also a distance relay.In addition to this EM
OCR and EFR are provided as back up protection and for over
current protection for conductors
| Is This Answer Correct ? | 24 Yes | 4 No |
Answer / vinay kumar
Mho relay is usually used for the protection of long
transmission lines as its operation is not affected by
power swings.
| Is This Answer Correct ? | 13 Yes | 4 No |
Answer / nagaraju n
in an long tranmission line protection purposes different
company make relays using.
NAME OF REALAY MAKE USING
REB-500 (ABB) BUSBAR PROTECTION
REL-670 " DISTENCC PROTECTION
RET-670 " LINE REACTOR PROTECTION
7SA522(SIPROTEC) ( SIMENS) DISTENCC PROTECTION
MICOM-P441
OHMEGA
REZ
SEL-321
T-60...etc
this relays are usinglong transmission lines protection
purposes...
| Is This Answer Correct ? | 5 Yes | 5 No |
Answer / mohd ibrahim
distance relay is used short & long transmission.
| Is This Answer Correct ? | 2 Yes | 11 No |
IDMT relays r used for long transmission lines protection
| Is This Answer Correct ? | 7 Yes | 28 No |
Answer / karthik
Relays are not used in Long transmission lines .. Only
circuit Breakers are used
| Is This Answer Correct ? | 4 Yes | 62 No |
why the starting torque is high in dc series motor..
If the load of transformer is getting more than its rating,,,than how to overcome this problem? Suppose thee rating of transformer is 315kva and the load is going beyond than the rating say around load: 352kva... Than how can we solve this problem without deducting the load.
One watt is equal to how many? we says one watt bulb,means what it consume?
magnetic circuit consume energy
how calculate gd2 of ht motors
0 Answers Hindustan Copper Limited,
what is the diffrence between preventive maintinance corrective maintinance?
What is The Resistance Formula
PLease anyone can tell me CTUM-15 specification?
I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.
What is reactive power and where it is used.
what is the difference between induction and synchronous motor?explain in simple words?why 3 phase motor is given preference over single phase motor.
Do anybody has a design software or tools for the selection and design of electromechanical components???
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)