What is method to calculate the noise level at any point of
duct if duct dimensions and air flow is known?
No Answer is Posted For this Question
Be the First to Post Answer
what is the length of a cigratte?
length l and width b is given for a rectangle.and the perimeter of a rectangle is denoted by p.another rectangle length is 2l and width is 3b and the perimeter of a rectangle is p1.find the ratio between those two perimeters?
where can find the information on 2R manipulator?and wat is the history of this 2r manipulator?
how gearbox ratio was calculated?
How do we calibrate the pressure transducer on the disharge line above our compressors? Or should it need calibrating?
what is the reasson after complition of suction stroke and started compression stroke inlet valve open for few digrees
substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section? (a)1J, (b)75000J, (c)90000J, (d)25000J
Explain why do the radiators in your house click when you start the heating system?
How does turbine work?
What are the usual checks when induction motor is running?
what is the size of A4 size paper?
Difference between clutch to torque convertor?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)