Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?

0 Answers  

---

Is the unit and normal value fuel ratio of an average diesel engine?

0 Answers  

---

On 22nd December, which of the following places has the largest day and shortest night ?

2 Answers  

---

Why green curtons are used in hospital?

2 Answers  

---

When I use two metal wire dowsing rods and walk over the septic tank,(or any other place where the ground has been dug up) they swing apart. What force causes them to move? magnetic, electrical, other?

1 Answers  

---

DAE Mechanical engineering interview questions

0 Answers  

---

. What is the hottest part of refrigerant in the refrigeration system

3 Answers   RRB,

---

WHY TORSION SHAFT IS GIVEN IN BALL MILL DRIVE. IS THIS HAS A ANY TECHNICAL REASON?

1 Answers   Satyam, Wipro,

---

what is inlet gas pressure of ge 9 fa gas turbine ?

0 Answers   Aegis,

---

Define monochromatic emissive power. [Ebλ]

0 Answers  

---

What i the role of a turning gear attached to a shaft line of a steam turbine

2 Answers  

---

What is the basis of selection of type of pump (Centrifugal, Vertical Turbine)

2 Answers   DAE, DCSEM, Energy Plus,

---