if we give DC suply to the AC motor what hapen

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / hussain

5 Answers
8670 Views
TATA, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if we give DC suply to the AC motor what hapen..

Answer / ajith

since there is no alternating current the dc current impenge
at the same point hence the single point will heated,and burn.

Is This Answer Correct ?

10 Yes

4 No

if we give DC suply to the AC motor what hapen..

Answer / sameer

and dc doesn't produce
alternating flux and
not a frequency
term,and resistance of
field and armature is
less it carry toooo
much current so
winding is burn out

Is This Answer Correct ?

4 Yes

0 No

if we give DC suply to the AC motor what hapen..

Answer / r.murugesh

The ac motor have input alternating both +ve and -ve cycle the dc supply only one +ve cycle so does't work in dc supply

Is This Answer Correct ?

2 Yes

0 No

if we give DC suply to the AC motor what hapen..

Answer / r.suresh babu

The AC motors are haveing a less resistance so,it will be
operates in only AC supply.In case of by giving DC supply
field windig is burn,after that motor is damaged.

Is This Answer Correct ?

1 Yes

1 No

if we give DC suply to the AC motor what hapen..

Answer / praveen kumar

No moter run in d supply ecause dc not have magnetik flux.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why voltages are multiple of 11 or 1.1???describe with derivation plzzz.thanks

2 Answers

what is creepage distance

2 Answers

What are the advantages of speed control using thyrister?

6 Answers

What is the formula for calculating no-load current?

0 Answers

what happen if we give square wave instead of sine wave to the transformer

8 Answers

what is different between IP55,IP54 and IP66?

2 Answers ABB, Global Industries,

when voltage increases current decreases & vice versa why it is so?

3 Answers

What are the advantages of nichols chart?

0 Answers

1)Why V cross Arm is used in transmission lines? 2)Why H cross Arm are not used in single poles?

1 Answers

Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss

0 Answers

an electric bulb is connected on a holder. one end of the wire is connected to the phase and the remaining one connected to earth instead of neutral. the bulb will glow or not? if yes then what is the need of neutral?

7 Answers

How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......

0 Answers

For more Electrical Engineering Interview Questions Click Here