Answer / hariharan

depends on the type radiator cooling system
1.thermostat type
2.thermosyphon type
but between engine and radiator only

Answer / a.rex silvester

between engine and radiator

Answer / singhal sharma

between radiator nd engine so as to exhale the air to the radiator for cooling purpose

Answer / manohar

Radiator fans are mounted between the radiator and engine,
fna couples and de-couples to engine according to
temperature changes.

Sometimes we use the Fan for condensers to have gigh heat
transfer, for Ex. if we are locating the condenser on back
side of vehicle of at different location then we need fan
which is mounted on condenser with shroud assembly

Answer / amit kumar sharma

BETWEEN ENGINE AND RADIATOR

Answer / hari

engine and radiator

Answer / mohit gupta

before radiator.

Will engine performance be damaged by mixing oil in fuel of four stroke bike ?

0 Answers  

Which mechanism is used in automobile gearing?

0 Answers   GM General Motors,

on how many points, an engine-clutch-gear box unit is supported on chassis frame ?

4 Answers  

Single reduction is used in final drive when it is about a) 6:1 b) 8:1 c) 10:1 d) 12:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

My Isuzu common rail 4Hl 1-1 tipper caught to flood & water absorb to engine through air intake line (air cleaner) then I put new pistons, rods everything its needed. But now when I start the engine its try to start with normal starting sound. I try to start until battery getting low, but nothing happen. What can I do? Please help me to resolve this problem.

1 Answers  

WHAT IS KING PIN OFFSET?

2 Answers   VECV,

What is meant by 1.8 tsi 4v 1798cc turbocharged?

0 Answers  

what is cpk value?

1 Answers   Nissan,

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

Tell us about the working of a 6-stroke engine.

0 Answers   Ashok Leyland,

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,