Answer / a.k misra

basically when we draw stress vs strain curve.......
then we assume neutral axis bt try to find exact axis to know
% of steel
op section is under-reinforced or over -reionforced
in both cases neutral axis will shift

Answer / anand858

when Ast is incresed

Answer / mkg

For a balance section neutral axis is fixed based on steel Fe415 or Fe 500 and concrete final crushing strength.
When section is under reinforced NA shift upward.
When section is over reinforced NA shifts down wards

how to know the one way or two slab

3 Answers   ASC, Harmal Enterprises,

---

how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???

0 Answers   Student,

---

5. Do you feel that your present employer estimates your full work potential? Are they pleased with your work performance?

0 Answers  

---

WHAT IS THE DIFFERENCE BETWEEN FACTOR OF SAFETY AND PARTIAL SAFETY FACTOR?

1 Answers  

---

what is idealized curve for concrere and steel

0 Answers   CSIL,

---

How many kilograms of 12 mm coarse aggregate required in cufic feet for one cubic meter of M25 grade concrete

1 Answers  

---

in m45 what does m and 45 refers

4 Answers  

---

what is the meaning of W.T.S this is written on structural Drawing

1 Answers   IES,

---

what is meaning of GSB? properties, ingradiant of GSB?

4 Answers   B L Kashyap,

---

what are the various types of pile foundation? explain with introduction

5 Answers  

---

what is difference between characteristic compressive strength and compressive strength of concrete

2 Answers   PWD,

---

how do measure the safe bearing capacity of soil? what is the compresive strength for concret?(max.&min.)

1 Answers  

---