how motor should be connected i.e star-delta or star-star
or delta-delta ?

Answers were Sorted based on User's Feedback



how motor should be connected i.e star-delta or star-star or delta-delta ?..

Answer / ashish sharma

STAR DELTA...BCOZ REDUCED VOLTAGE IS APLLIED IN STARTING AS THE STARTING CURRENT IS VERY HIGH...IN STA CNNECTION VP=VL/UNDER ROOT 3...

Is This Answer Correct ?    3 Yes 0 No

how motor should be connected i.e star-delta or star-star or delta-delta ?..

Answer / guest

delta star

Is This Answer Correct ?    2 Yes 2 No

how motor should be connected i.e star-delta or star-star or delta-delta ?..

Answer / deepak verma

3 phase motor connected in stardelta connection because high value of current required to motor to attain its rated speed which is obtained by star delta....its increse the starting current by root 3 and reduce the voltage by root 3

Is This Answer Correct ?    0 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

what is mean by harmonics

1 Answers  


How the oil level of the Buchholz Relay come down.

3 Answers  


What is the relationship between voltage,current & frequency?

0 Answers  


What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.

0 Answers   Mind Tree,


What is the main function of fuse?

7 Answers  






what is rise time and half time

1 Answers   NHPC,


I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.

1 Answers  


I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.

3 Answers  


why motor rating in KW?

2 Answers  


Why the voltage n frequency of the incoming generator is kept slightly higher than d grid voltage n frequency while synchronization ?

4 Answers  


Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only.

12 Answers   ACC, JLL, ZETDC,


When we giving the 3 phase supply to ups system how to coming netural?

0 Answers   Juniper Networks, Tata Motors,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)