why transformer comes only in standard rating like
11kv,33kv,66kv....and not like 33.33kv and so on?
Answers were Sorted based on User's Feedback
Answer / suraj kumar padhan
The lines are rated in this way because our form factor is
constant which is 1.1 so for easy calculation it is rated in
the multiplication of form factor. reason behind it is if we
know the form factor than we can calculate the average value
and rms value.
| Is This Answer Correct ? | 17 Yes | 1 No |
Answer / e.b.n chowdara
Generally Power transformers are placed in Transmission and distribution lines, so these line are stranded ratings like 11kv,33kv,132kv,220kv,400kv. So transformer voltage rating are like that.
| Is This Answer Correct ? | 8 Yes | 13 No |
Answer / guest
This is the standard rating of supply companies in India.
So in India you will find 11kv, 33kv and 66kv and above,
But if you go abroad like Saudi its 13.5kv etc.
It all depends on which country you are in. Our country
frequency is 50 cycles per second. But in US or Japan its
60 cycles per second.
| Is This Answer Correct ? | 4 Yes | 10 No |
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
7. A resistance of 30 ohm is connected across 240v supply. If a resistance R ohm is connected in parallel with 30ohm resistor across the same supply, the current drawn becomes triple of original one The unknown resistor R is
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
how is the magnetic current test is different in delta-star and delta delta transformer.
How to do the meggering for a cable.
Why transmission line carryiny high voltage and low current?
3 Answers apspdcl, Universal Power Controls,
what is ferranti effect?
WHAT IS A DIFFERENCE BETWEEN A DC GEAR MOTOR AND STEPPER MOTOR.AND WHICH IS MORE APPROPRIATE TO USE FOR POSITION CONTROL PURPOSE?
electrical
what will happen if there is a voltage leakage or current leakage in an electrical train
What is a roll of adopter panel in terms of h.t. Panel ???
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)