can you tell me how many stages in steam turbine of 10 MW
power plant
Answers were Sorted based on User's Feedback
Answer / mithilesh kumar
In steam turbine its totaly depends upon require steam from
extraction of turbine.
but 10 mw seam turbine must be 9 stage.
the biggest reason here ur power plant is which type.
capitive power plant or power station.at the extraction of
steam wre r u used.
Is This Answer Correct ? | 9 Yes | 1 No |
In steam turbine its totaly depends upon require steam from
extraction of turbine.
in our 135 mw powerplant it get 14 stages.
Is This Answer Correct ? | 0 Yes | 0 No |
how the 4 to 20 mA signal goes to any controller/indicator,and what is the role of voltage ,12/24 and how to do connection of it, in controller.
What is calibration?
what are the on/off valve precaution?
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
how can we measure the pressure in underground cooling water pipeline by using pressure transmitter?what about the tapping position?
how many parts of valve positioner?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
How can we say that accuracy of measurement increases by using 3 or 4 wire RTD? because for example: If resistance of RTD element is say r ohms and Resistance of the cable from transmitter to RTD is R ohms And if 4 wire RTD is used, ____._____________________ R ohms | |_____._____________________ R ohms / \ / r ohms \ \ | |______.__________________ R Ohms | |_______._________________ R ohms Then the actual resistance measured will be: Total = r + R/2 + R/2 = r +R Ohms Note: r+R instead of r ohms. hence error
what is proportional & what is proportional band
why is the sleeve of the cable used for?
what is datum line?
Could anybody pls give ans of boiler 3 element control system?