Answer / tanweer

we know for series motor
speed is proportional to back emf/load current.
if there is no load then load current is zero.
zero load current means speed is infinity which will cause
harm to the motor.that is why series motor is always
started with load.

Answer / arun

for series motor. no load means no current.
speed inversly proportional to current, so at no load motor will run dangerous speed.it damages the motor

Answer / vishwa theja c

in dc motor speed is directly proportional to (v-i*r)/(flux). in dc series motor flux is depend on load current. if no load current speed is infinite and it is dangerous and un satisfactory.

Answer / abhishekkumar

Motor armature current is decided by the load. On light load or no load, the armature current drawn by the motor is very small.

In case of a d.c. series motor,

Φ α Ia

and on no load as Ia is small hence flux produced is also very small.

According to speed equation,

N α 1/Φ as Eb is almost constant.

So on very light load or no load as flux is very small, the motor tries to run at dangerously high speed which may damage the motor mechanically. This can be seen from the speed-armature current and the speed-torque characteristics that on low armature current and low torque condition motor shows a tendency to rotate with dangerously high speed.

This is the reason why series motor should never be started on light loads or no load conditions. Foe this reason it is not selected for belt drives as breaking or slipping of belt causes to throw the entire load off on the motor and made to run motor with no load which is dangerous.

Answer / vamsi

DC MOTOR IS NOT STARTED AT NO LOAD
BECAUSE STARTING torque OF DC MOTOR IS HIGH....

Can Induction motor run at over rated speed? ( 15oo rpm is rated speed for 50HZ. is it possible to ride 3000 RPM with same motor with the help of VVVFD for continues ride of 100HZ)

3 Answers   Equate,

plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in

0 Answers   Bhel,

KVA transformer of different frequencies of 50hz,100hz,500hz&1000hz. which one of these transformer has big size? Give reason

4 Answers   Suzlon,

what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.

0 Answers  

how do find power factor in practically and what it means?

3 Answers  

1)What will be full load current for 1000kva 3 phase generator. 2)What will be full load current for 20Kva 1 phase inverter.

5 Answers  

my 10 hp submersible pump is tripping when connected through ELCB.I have checked the megger value of the coil's with body.It was found to be 0.2mega ohm.that is leakage is there.But when connected to mccb it is not tripping.no leakage current in the motor.Is it safe to connect to mccb? what are the problem's will arise if future?also tell me in ELCB no neutral is connected to motor.than how ELCB was working?

1 Answers  

why VCB always installed only at HT yards or HT side? suppose if ACB installed at there means, what will be problem?

1 Answers  

why three phase capacitor takes unbalanced current in capacitor bank?

0 Answers   Aggreko,

My meter ratio is -/5 and ct ratio is 100/5 now what will be the multiplying factor and how ?

1 Answers  

what is the affect of earth's magnetic field on the frequency used in aircraft???

0 Answers  

What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?

0 Answers