what is the difference about HART, and 4-20mA signal?

8 Answers  

---

My question may be very basic or childish but this question still persists in me, someone plz help me 1.why do we go for differential equations to analyze a system? 2.why do we solve it using matrices, is there any specific reason for using matrices other than the stories like it is simple,faster etc.

2 Answers  

---

In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.

0 Answers  

---

What is meant by cold float of compressor shaft.

1 Answers   Sabic,

---

for what purpose strain guage is used?

5 Answers  

---

How to do manual mapping in radar type level transmitter?

2 Answers  

---

What is flow ,level, pressure transmitter ?and units?

2 Answers  

---

Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72

0 Answers  

---

how can calibrate transmitter online

2 Answers  

---

I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.

0 Answers   RasGas,

---

What is the maximum operative of Drive ?

2 Answers   Reddy Labs,

---

any questions on motor and energy conversions machines?

0 Answers   ABB,

---