Answer / pandiyan.m

singly reinforced beam is reinforced at tension zone alone
and doubly reinforced beam is reinforced at both zones and
difference is singiy cannot take too much loads

Answer / himel

when rf is reqd in only tensile zone of beam, its called
singly rc beam, when moment is large enough is to reqd to
provide rf at compression zone also,called douly rc beam.
load variation is the only difference betn these two.

Answer / kamal pandey

single rc beam is reinforced at tension zone only and doubly
rc beam is reinforced at comperesion & tension
zone.difference is singly cannot take too much loads

Answer / vasanth

In singly reinforced beam limiting moment of resistance is higher than design moment. And the reinforcement designed for tension zone only.
In doubly reinforced beam limiting moment of resistance is lower than design moment. And the reinforcement designed for both tension zone and compression zone.

Answer / desai ankit

In singly rc beam,reinforcement is provided on tension side only.While in doubly rc beam ,reinforcement is provided on compression

Answer / anil kumar

singly rc beam is defined as in which single bent up bar is
used & doubly rc beams may be defined as in which two or
three bent up bar are used are termed doubly reinforced beam

How we decide the depth and size of footing? Give a example?

1 Answers  

how to calculate stair case landing slab bottom shuttering marking,angle of stair case? top landing length-1250mm treads length-2700mm(9X300mm) rise length-1500mm(10X150mm top landing level +1.5m lvl bottom level-0.00m lvl

3 Answers   Thermax,

What do we mean by partial moment release ??

0 Answers  

what is the meaning of morth

1 Answers   L&T, Maytas,

why there is curve at the end in channel sectin

3 Answers   Birla, GNFC,

how will remove spiderweb cracking in plaster ? what the reasone of make it ?

0 Answers   Bharat, JLV,

why cylinder for split tensile strength test ?

1 Answers   HCC,

what"s the formula to find the cement,sand,aggreegate(45mm) requirement for PCC?

5 Answers   L&T, Radiant Fire,

Mention different types of roof systems?

0 Answers  

qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor

0 Answers  

Howmuch bend to be provide for 200/600 BEEM

0 Answers  

Pile height is 4.3m. 2nos. under reammer. bulb nose is 75mm and height is 400mm. pile dia is 375mm and overall dia 940mm.pls. help to calculate concrete in pile and bulbs separately. What is formula for bulb volume calculation ?

0 Answers