Answer / dineshrambalaji
it is a closed cycle in which heat is rejected/added from/to the system by doing work. it usually involves four steps
|Is This Answer Correct ?||12 Yes||2 No|
what is the role of mechanical engineers in i.t.industry?
PLZ. PLZ. PLZ. Pay attention can i have details regarding QMS/SPC/MSA/TS16949 ?????
Air is a bad conductor of heat.why it becomes hot in summer?
What creates speed in centrifugal pump ?
I want to model a piezoelectric beam in ansys software.How can I model the electrical circuit and how can I read the general current and voltage produced by the PZ?
how does an EDM works?
Two shafts A and B are made of same material. The diameter of the shaft B is twice that of shaft A. The ratio of power which can be transmitted by shaft A to that of shaft B is
Numeric control is used for
on which part of the flywheel energ will get be stored?
What is the maximum P-max for a cylinder in M/E.
Abrasion is a cause of the gear failure form
What do you going to observe, when a diesel engine is running?