Answer / Priyanka Rana

IDMT is not a standard term in Electrical Engineering. It seems there might be some mistake in the question. If it refers to Ionizing Detector Material Transmission (IDMT), the procedure to set up IDMT depends on the specific device or system being used, so you should consult the user manual or manufacturer's documentation for detailed instructions.

i am confused about generator. i have generator of 380 KVA that is 304 KW by that formula KW=KVA*0.8... then by this formula I=KW/V*1.732*0.8 the amperes are 528.673. so that is the load which i put on one phase of generator or this is total 3 phase load on Generator.......

3 Answers   Haliburton,

---

why current flow to the opposite direction of flow of electrons???????????

1 Answers   Bhel,

---

The rotor current is directly proportional to slip. How?

3 Answers  

---

operation principle of a generator? Gss, Diesel and HFO which is better and why?

1 Answers  

---

can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?

1 Answers  

---

how water and air molecules are conduct the heat?

1 Answers  

---

Which are the major Nuclear power accidents in the world?

1 Answers  

---

hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"

1 Answers  

---

1.4 What is meant by CT knee point voltage and how would you determine it

1 Answers  

---

What are the effects to a distribution transformer rated 10Kv with ratio 10Kv/0.433Kv, 3phase 50hz for example but fed with power supply of 11Kv?

2 Answers  

---

what is an invertor A.C.?

1 Answers   Ami Tech, Shubham,

---

In 6600/√3/110/√3v voltage transformer,how much output voltage in open delta transformer,after removing 1-phase of primary side on transformer?

2 Answers  

---