What is the difference between local indicator(flow) and
flow indicator?
Answers were Sorted based on User's Feedback
Answer / m arif
1 local indicator are rota meter , m3 ltr and auther rate flow
show to line in field.
2flow meter (element)are in transmitter show to control room,
and local field room.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / ramesh dham
Flow Indicator/ Totalizer Not just a digital indicator but it is a flow calculator. In Flow Totalizer three inputs are taken (DP, Pressure & Temperature).It make density correction for volumetric flow to make them mass flow.
Local Indicator for just display of Flow can be of any digital indicator with 4-20 mA input.
Is This Answer Correct ? | 2 Yes | 1 No |
which instrument is used to study the structure of phloem and xylem tissue?
what is span value and zero ? and how set ?
Y to use 4 to 20ma instead of 0-10v
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
How to calculate the range of level transmitter?
what is the resource block mode in foundation field but ? what is advantages for this
1. What means HART communicator / where it is used / how to use it? 2. Types of Thermocouples and its temperature ranges / output of thermocouple? 3. Types of RTDs and its temperature ranges / output of RTD? 4. Idea about Temperature Transmitters? 5. Difference between Analog and Digital signals? 6. Difference between “2 wire” and “4 wire” system / instruments? 7. Difference between “Potential” and “Potential free” contact? 8. Types of flow meters / transmitters? 9. Types of level transmitters? 10. Difference between “Power/Control” cable and “Instrument” cable? 11. What means “shield” and “screen” in cables / how it is useful? 12. Draw a schematic of closed loop circuit of flow / level / pressure / temperature? 13. Idea about calibration of Control valve / positioned / I/P? 14. How to bypass a digital/analog signal in PLC/DCS by hardwire and software?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
what is vibration sensor working principal and how many types its has??
Why the tapping connections are taking above for gas service and below for liquid service?
what is solenoid valve?
I am working in a process industry, in that there are several sections devided in the SCADA screens and individual sections may START independently. But sometimes i am facing problem i.e, if section 2 Stopped by the operator immediately Section 1 or Section 3 or Section 4 is getting stopped can you expain the reason behind this?