Answer / rajdeepghosh8

current chopping in CB is the incident of arc current
interruption before normal current zero is reached.If This
current is enough to deliver a voltage which is greater than
restriking voltage then the arc will continue again. But
gradually the current falls and certainly the voltage also
reduces and finally fall down the restriking voltage and
ultimately arc is extinguished. It results in voltage
oscillation in the line which affects the electrical
equipments.

what is phase angle and how its generate moreever how we measure the phasse angle?

1 Answers  

---

how to set relay setting? and example calculation...

0 Answers   JSW,

---

WHY RATING OF VCB NOT LESS THAN 630A

0 Answers  

---

give me list of material for wiring of 20hp motor?

2 Answers   Alchemist,

---

how can we run the induction motor at 9000 rpm ,by keeping frequency constant??

2 Answers  

---

How many watts required for single phase power supply?

4 Answers  

---

is it possible to test of bus bar in high rise building without completed full floor ?

0 Answers  

---

Why armour HT XLPE power cable required to Earth?

1 Answers  

---

what is the significance of positve n negative voltage regulation .on alternator

1 Answers   TCL,

---

Is it advantages of having star-delta vfd than normal star vfd , if yes why?

0 Answers  

---

plz tel me syllabus and exam date 4 jr executive engg (electrical)

0 Answers   AAI Airports Authority Of India,

---

why steady state stability limit is greater than transient stability limit ? How it can be explained ?

0 Answers  

---