Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajdeepghosh8
current chopping in CB is the incident of arc current
interruption before normal current zero is reached.If This
current is enough to deliver a voltage which is greater than
restriking voltage then the arc will continue again. But
gradually the current falls and certainly the voltage also
reduces and finally fall down the restriking voltage and
ultimately arc is extinguished. It results in voltage
oscillation in the line which affects the electrical
equipments.
| Is This Answer Correct ? | 50 Yes | 10 No |
Post New Answer View All Answers
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
can i connect wavetrap in 2 different phase in EHV line?
Why colled 440V to 3-phase supply.
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
Why the output of OP-AMP is always less than Vcc?
plz explain the auot-reclosing circuit in electrical engineeing
how to deside the capacity of chock for drive?
Define steady state error.
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
Hello sir i m student of gtu .what is idp.
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
why we used ZNO in Lightning arrester.
