Answer / doli tomar

When a relay is used to switch a large amount of electrical
power through its contacts, it is designated by a special
name: contactor. Contactors typically have multiple
contacts, and those contacts are usually (but not always)
normally-open, so that power to the load is shut off when
the coil is de-energized. Perhaps the most common
industrial use for contactors is the control of electric
motors.

Answer / sdr

The function of a contactor is to make or break the circuit
on receiving a command.It is used to design auto ckts.

Answer / baljeet singh

The contactor means the contact to make or break the circuit with useful protection.basically contactor used in starter circuit.

Answer / dilawer

contactor has main function to control the power through
low power (push button etc.)

Answer / michael

Contractors are used to make and break high current circuits basically in industrial motors

Answer / raghavendra m.

Contactors are electrically control switch used to switching electrical circuit.

Answer / s

function of contactor is to make or break circuit

Answer / bagh ali

device used to make or break the circut

Answer / sridhar

where the no. of operation is more, this contactors are
used.

I have 480V Single phase and I am trying to figure how big of a transformer (KVA's) and Primary breaker size I need to provide 200 Amps at 240V for a building.

1 Answers   Wipro,

pls tell me function of closing coil of A.C.B.

0 Answers  

what are the deffects for failure of PLC?

0 Answers  

How does the humidity affect in breakdown voltage of air?. Is the breakdown voltage increases with the humidity?

2 Answers  

Why the wave trap is put in Y phse only in switchyard?why not in other phases?

1 Answers   IAG Automation, REL,

difference between ceiling fan

24 Answers   Altius Technologies, Raisoni, TCS, Uni Deritend,

What is the maximum size(MVA)of power transformer available in the India/world?

13 Answers   Adani,

how is capacitor bank look like

0 Answers  

what is the purpose of checking IR and Megger values in motor windings?

5 Answers  

. What should be the minimum and maximum ohmic value for earthing?

1 Answers  

Can any body tell me the different types of LT cables & their application.

0 Answers  

How to improve the power factor from 0.8 to 0.98? Also tell me cost vs benefit analysis.

2 Answers