what happens when we give ac supply to the dc motor?and why?

Question Posted / vijayakrishna

4 Answers
9032 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what happens when we give ac supply to the dc motor?and why?..

when an ac is given to a dc machine ,current under north or
south poles change their direction 100 times per second
so ,ideally it should move to and fro motion continously
which may cant work practically

Is This Answer Correct ?

4 Yes

0 No

what happens when we give ac supply to the dc motor?and why?..

Answer / rakesh kumar

It all depends upon whether the motor is a series motor or
shunt , if the motor is series then it would be running but
quite unsatisfactorily with increased sparking during
commutation and heating. however a shunt motor wont run
because of the high inductance of its field windings ( due
to greater no. of turns ) it will oppose the change in the
magnitude and direction of current which is th case with
ac .

Is This Answer Correct ?

3 Yes

0 No

what happens when we give ac supply to the dc motor?and why?..

Answer / varun

It depends on the construction of the motor.If the field winding is connected in series wit armature winding,the motor is like universal motor and will probably operate normally.if the field winding is connected in parallel to the armature winding ten motor will draw current and it will get hot and damaged

Is This Answer Correct ?

2 Yes

0 No

what happens when we give ac supply to the dc motor?and why?..

Answer / bardala satish

when ac supply will give on the dc motor then rotate dc motar but after few second winding will start to burn due to heat loss and motar will be damage

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours

0 Answers MRF,

In Transmission System if the potential difference at the two end of line are same then is the transmission of power will continue ? if yes then how.

1 Answers IOCL,

why ht line fuse wire is so thin

7 Answers DLF,

how DC is differ from AC ? what are the difference between them ?exept (P-N)&(+__-)

2 Answers

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

0 Answers

Shall we use Dyn1 transformer in place of Dyn11 for motor application as a distribution transformer

1 Answers NSL Sugars,

What is essential to prove safe isolation of electrical circuit?

0 Answers

Wtat is vaccum currcuit breaker.define with cause of used.and where be use it Devise .

1 Answers

IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN OUTPUT (THAT MEANS TERMINAL SIDE OF THE INSRUMENTS) I,M RECEIVING ONLY 6 VOLTS, WHAT IS THE REASON FOR THAT MUCH VOLTAGE DROP?

3 Answers

what is dead tank CT AND what is live tank CT

2 Answers TATA,

If Two Generators are working parellel in a network and suddenly the field of one Generator get weakened What will happened if there is no reverse power relay fixed in that Generator panel????

7 Answers

what are the various types of earthing? plz give brief detail of all. also post pictures if u have.

22 Answers Aster Teleservices, Era Infra Engineering, Micron Electricals,

For more Electrical Engineering Interview Questions Click Here