Answer / guest

because transformer output power depends on total losses i.e
iron and copper loss

Answer / tank

The transformer is an apparatus which receives the power in
VA,KVA or MVA rating depending upon the capacity of the
transformer and it transforms/supplies the power under same
rating to a particular load when it is connected to a
transformer.In this process the power factor of the
connected load decides the KW rating(KVA X P.F = KW).Hence
transformer rating is never given in KW but always in VA,
KVA or MVA at manufacturing stage as there is uncertainity
of the type of the load and power factor to be connected
with the transformer.

Answer / parthi

The copper loss of
transformer is depent
on the current and iron
loss is depent on the
voltage. The losses
are does not depent
on the frequency so
the transformer
ratings are in Kva not
in kw.

Answer / sunil

Transformer is electrical equipment and hence delivers in
rated KVA. kW is what we use after pf, losses etc.

Answer / baljeet singh

The transformer is a power source device ,It transformer electricity from one medium to another medium.Due to this power factor not take on part.So transformer rating alwas in kva not in kw

for 500mw power production how many range of transformer set in unit please reply if three transformer use .

2 Answers  

what is stper motor

0 Answers   Bhel, WAPDA Water and Power Development Authority,

what is the response time of relays when a FAULT OCCURS IN A POWER SYSTEM?

2 Answers  

What is the use of Isolation Transformer, and Neutral is using for return path, finally this current is going.... but same time the voltage of the neutral should be below 1 V...

6 Answers  

Why is transformer connect parallel? why not series? ....plz...

3 Answers   wbsedcl,

I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.

2 Answers  

what is bus pt and what is the function of it ???

8 Answers   TATA,

Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV,20kV, 30kV?

2 Answers   Bhel,

why aggregate is placed all around substation ground.

9 Answers  

how to calculate the current capacity of a wire if its dimension in Square mm is given

1 Answers   TATA,

What is core balancing in Power Transformer. What is the affect of an unbalabce core.

1 Answers  

We have a bank capacitor rating of 60 KVAR for a overall load of 160 KVA and we have connected three loads of 50KVA each. We would like to auto matically correct PF using APFC. How do we design it?

2 Answers