WHY TRANSFORMER RATING IS MENTIONED IN KVA RATHER THAN KW
- 5 Answers
- 8343 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
because transformer output power depends on total losses i.e
iron and copper loss
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
What is different bewteen low or high impedance busbar protection scheme
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
Define stepper motor. What is the use of stepper motor?
any one can explain the stages of a knee point which is taken during ct magnetising curve.
Is there any guideline say about display of earthing value near to earth pit
What is the difference between earthing,ground&nutral?
hi, could someone help me to find a control design for syncronising panel .
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
What are the advantages and disadvantages of open loop control system?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
importance of reactive power management
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
How can we increase fuel-power ratio of any DG set?
What is a signal flow graph?
errection check list for transformer maintenance
