Answer / Mayank Jaitly

To diagnose a rotor earth fault in a generator while it is running, follow these steps:

1. Ensure that the power supply to the generator is isolated and lockout/tagout procedures are followed for safety.
2. Inspect the voltage regulator settings to ensure they are correct for the load conditions.
3. Check the grounding system for any loose or damaged connections, including the rotor ground.
4. Measure the resistance between the generator frame and the ground. A low value indicates a possible earth fault.
5. Perform an insulation resistance test to verify the integrity of the insulation between windings and ground.
6. Inspect the rotor shaft for any signs of damage, such as cracks or wear.
7. Check the rotor winding resistances to ensure they are within acceptable limits.

if any leas acid battery is having low or high sp.gravity taen what will be effect of battery and why

4 Answers   CFCL,

---

calculation of lad carryinc capacity of 6mm2 cross section wire in 415 voltage circuit. What will be the amps.

0 Answers   MAHINDRA,

---

difference between ordinary MCCB & Motorised MCCB

4 Answers  

---

Can you any one explain different between instantaneous over current and IDMT

1 Answers  

---

how we select HRC FUSE ?

1 Answers   AXA,

---

What is a Servo Stabliser.

2 Answers  

---

why does voltage generation at 11 kv?

2 Answers  

---

why transformer rated in KVA not in KW ? we know that W= v*i

6 Answers  

---

we have 400kv/6.6kv transformer ,it has total 9 taps on HV side with normal tap on tap no 5.when we took the ratio test we observed that ratio was decreasing from tap 1 to tap 5 and was found increasing from tap 5 to tap 9.What is the reason?if anyone have related document then please send me on the email id ankushbahale@gmail.com......plz plz

1 Answers  

---

what will be the efficiency off x'mer during no load test and during short circuit test

1 Answers   GPSC Gujarat Public Service Commission,

---

If the generator will trip, what you will do as an electrical technician in charge.

1 Answers  

---

what are safety seals in HT line?

2 Answers  

---