Answer Posted / franco ambrose s
Supercharging is the process of increase the inlet air
pressure.actually supercharging method is done in gasonline
(petrol engine )here separate battery is needed to compress
the inlet pressure.because the exhaust gas wont be high
pressure as in diesel engine.
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Checking points in steering gear system?
why mechanical engineering in US universtiy??
I WORKED AS A Q.C INSPECTOR IN STATIC EQUIPMENT.WHAT ARE THE QUESTIONS ARE LIKELY TO BE ASKED IN AN INTERVIEW.
what is the rpm of Turbocharger of Cummins KTA50G3 Diesel Engine?/ Normally What is the rpm of Turbocharger for any 1 MW Engine?
How convective heat transfer is effected and on what factors it depends ?
What do you mean by annealing?
i am preparing for vsp management trainee technical 2010.can any one send me modelpapers of preliminary written test.
Why did you choose this career?
i want technical question of mechnical for rrb mumbai
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
Hello there, Im a Mechanical Engineer. I passed out in 2010 and have worked for 6 months in the Middle East as a Trainee Engineer. Im now in India and due to appear for an Interview for a firm in the Middle East. The post is of an Automobile Engineer. Im kinda nervous as to what to prepare for the interview. The training which I got was in different areas ranging from technical to managerial aspects. What I mean to say is that that was more of a crash training, where I couldn't stick to one section alone. The interview which Im attending is more of a technical one. What I would like to know, how and what I should be preparing? I have two weeks for the preparation. Should I go through the normal automobile aspects or everything in random. PS: I have excellent communication skills, the one area in which I'm very confident.
Low water in boiler drum is unsafe because it may result in overheating of water tubes in furnace. Why it is unsafe to have high water condition in boiler drum ?
Have you been a team leader in your previous or present job and what are the challenges of associated with team leadership?
What parameters to be reported when we send lubricating oil for shore analysis?
Is Solid work and solid edge best programs for drawing? what is the difference bewteen them? r there better softwares?
