I have an existing old MCCB. ABB Model SACE, the rating
are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800
amps at 45 deg C. I need a circuit breaker for my 3 phase
motors, 380 volts 60 hz. the supplier required the minimum
ampacity of the breaker to be 911 amps. can i use this
breaker with rating of Iu =1250 amps but Ith = 800amps
maximum?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

how we calculate the motor rating of pump for water suction ?its any formula for that plz give thank u

3 Answers  


three owners X, Y, z owned some tractors with them, on the first month x gave away the same amount of tractors to y and z ( as much as they possed), similarly in the 2nd month y gave of to x and z similarly by third month z gave to x and y. after this all X, Y, Z had 24 tractors each.

2 Answers   econ,


How can we get a Neutral from a three phase suply? If we meet all three phases at a point to take neutral then why dont thay get sparked?

1 Answers  


The DC current waveform is - . What about the fire alarm waveform?

1 Answers  


what is model question rrb junior engineer electrical gr.II

0 Answers  






In domestic supply, when neutral touches earth the earth leakage trips. Does this mean that if the star (neutral) point of an alternator is earthed that power will flow to earth i.e. a direct short to earth?

1 Answers  


i need to connect fact device(any one from following upsc,sssc,svc,statcom and tcsc)in 14 bus system....by using MATLAB psat software....if i connect these fact devices,i will get some error as "virtual error"...i cnt rectify this error.if anybody know that how to work in psat,pls help me to rectify this error.... or send mail me to, viki0607@yahoo.co.in

1 Answers  


How can a equal potential zone be carried out in conductors?

0 Answers  


why the neutral point of star connnection oscillates?

3 Answers   Avalon,


Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?

0 Answers  


how is the incoming cable size calculated for a given current rating of a panel??

0 Answers  


What do you mean by cold shinkable cable joint.How it is done.

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)