what is the speed of a turbine in an hydroelectric power
station and how many poles does it have...?



what is the speed of a turbine in an hydroelectric power station and how many poles does it have....

Answer / a

usually hydroturbines are low speed turbines.speed is 500-600 rpm and they are 10 pole or 12 pole machines

Is This Answer Correct ?    1 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

how to calulate transformer secodary fault A?

1 Answers  


What are the causes for the failures of sandwich type (Al) busducts?

0 Answers  


What is the safety protection? Name the protections of Transformer?

1 Answers   HSL,


How to calculate cable size? How to O&m of vcb?

0 Answers  


how to calculate the tarriff for an industry whose kva demand is 10 mva

0 Answers  






How can we calculate ngr resistance for a generator and Transformer ? What type of transformer requires ngr ?

5 Answers   Welspun,


What will happen if " not connecting the neutral point to ground of diesel generator output (380 V)", also if someone touched one phase without isolation from ground during the A/M condition what will happen to him?

3 Answers  


We have 2 no. 4MW DG set. and GEB supply. But, we running, only 1 DG set. when we done APFC/Power factor setting : 0.90, then winding temp. Low. but when setting done : 0.83, then Winding temp. increase. WHY Why ? ? ?, plz give me answer.

4 Answers  


In 110V DC supply,if a closed circuit gets open, How can we identify the voltage which is measured after the resistor(4KOhm) which is open with negative.it shows 55V +ve when measured, also the actual positive source is 55V +ve .Because there is no voltage drop in open circuit. How can we identify whether this is the voltage which is series with the resistor or the DC source direct +ve.

1 Answers   GE,


what is the reason for drop in freq. from 50 hz at generating side to 49.8 ,49.6 etc.at receiving side???

2 Answers  


How to megger test 11 kV cable and the acceptance IR value

0 Answers   BVG, NFL, ONGC,


how many joint can done in HT line and what is life of the joint

0 Answers   Micro Labs, Reliance,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)