Answer / sreemani84

by reducing the unwanted load.

by increasing the chiller temp. in the night time

by switch OFF the unwanted computers.

Answer / aboli desale

1.Switch off lights & fans when not required.
2.Proper & regular maintenance of Air Conditioner can serve
a lot.
3.keep computers in sleep mode when not in use.
4.maximise use of natural light.
5.Use of electronic type regulators insted of old mech.type
for fans.saves abt 9 watts /fan.

Answer / kaushik panchal

by swiching off our office light fan, ac after leaving the
office

Answer / geneliya disuza

by using LED LAMPS AND ALSO CFL LAMPS

Answer / guest

by using cfl lamps

Answer / sreemani

thnkx desale

how to decide cable rating? send me cable size,ampere rating data

2 Answers   Bhel,

What is creepage distance..... what will be the value for different voltage level

0 Answers  

is there any difference in reading or error in value, if we connect the R phase in Y terminal and Y phase in R terminal of electronic energy meter of 11 kv feerders???

1 Answers   KSEB,

what is EIB lighting control system? what is the advantages of this system?

0 Answers  

How to decrease or increase the range of voltmeter? can an ammeter be used to measure voltage? can a wattmeter used as voltmeter and ammeter?

3 Answers  

Why does capacitor block dc supply?

5 Answers   Bhel,

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

why dc motor is called constant flux motor?

1 Answers  

wht factor are considered to design ACB( air Circuit reaker) 415V

3 Answers  

what is percentage impedance of transformer? explain its significance

2 Answers   ABC, Bosch,

how to make parrallal ups

1 Answers  

what is the diffrence between R Y B phase and why it is called RYB

5 Answers