What are books to be referred for KPTCL exam?

0 Answers  

---

What is the formula to find out cross sectional area of cable for certain current rating?

1 Answers   MRF,

---

I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)

1 Answers  

---

at what base you will tell the direction of rotation of dc motors and generators?

0 Answers  

---

how much excitation voltage required to generate 1mw power?

0 Answers   Saudi Oger,

---

The undesirable property of an electrical insulating material is

3 Answers  

---

In CTs tan delta point should be earthed , what is the reason behind it?

0 Answers  

---

what is an impedance & inductance ?

4 Answers  

---

Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com

0 Answers  

---

what is form factor?

3 Answers  

---

what will happen if neutal in AC ckt will get open

3 Answers  

---

Before i went to bed my master bathroom lights were working fine. At 2 am, when I went to use the lights, none of them were working. The outlets throughout the bathroom work, but the lights and fan above the toilet don't. I have two panels of switches. The one panel has four switches. One of the switches turns on the hall light, and that works. The other three are to other lights, and they don't. The other panel has three switches. One of those is to the fan, and the other is to a light above the toilet. The other is a to light that is also on that other panel. I tried the breakers, and the one that turns off the outlets, marked for the bathrooom, turns on and off the outlets. None seemed to be tripped. I checked the lightbulbs, and they are fine. Please help

2 Answers  

---