what is phase angle ? and also tells me why my phase-phase
voltages are 390 rather then my single phase voltages are
221 and 223 respectivly?
Answers were Sorted based on User's Feedback
Answer / joel q.
Phase angle this the angle that separate each of the line
voltages in a three phase system; normally for a 3P balance
system each of the line voltages are separated 120 degree.
If Phase voltage is 220 volts,
Phase to phase voltage is 1.732*220 = 380 volts
Is This Answer Correct ? | 7 Yes | 0 No |
Answer / ramanjaneyulu
it is the ratio of true power and apperent power.
because the potential between two phases is 415v. 5%
tolerance.
the potential between phase and nutral is 230v
Is This Answer Correct ? | 0 Yes | 2 No |
how to protect motor in dol starter having capacity of 30 hp.40 hp?
in india per day how much power is generated including all power station
What does the term power factor shows?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
What is trip and closing coil in cb? Why need of them
why the power cut problems occur in tamil nadu? may i know the exact reason.plz
We have 11kV/110V three phase indoor potential transformer in 66/11kV Sub-station, where the failure of PT is frequently happening and the rating of the PT is 0.2 class accuracy, with primary star and seconday (two cores) star connected. Some experts has suggested to not to connect the PT Primary neutral to the ground because when transformer neutal NCT connection is loose; the faulty current will flow through the PT primary neutral, resulting into failure of PT. My question is: Is it necessary to remove the primary neutral connection of the PT from ground? if not, what would be the reason for failure of PT. Please guide me.
Why VL is more than the Vc?
I decided to provide a 11KV / 440V Xformer in my Substaion. What are the protection required for that?
what is the different between Switch & Circuit Breaker?
how to build a network which step down 415v to 1v rms
Please define ampere?