Interested to Buy Any Domain ? << Click Here >> for more details...
what is phase angle ? and also tells me why my phase-phase
voltages are 390 rather then my single phase voltages are
221 and 223 respectivly?
- 2 Answers
- 4616 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramanjaneyulu
it is the ratio of true power and apperent power.
because the potential between two phases is 415v. 5%
tolerance.
the potential between phase and nutral is 230v
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Basic motor transformer generator
why u r living from presentaly working.
what shoud be strength and weakness to impress interviewer????????
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
what is zinc diffusion?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How LT megger works ?
Mention the methods for starting an induction motor?
how test transfomer(3 phase75kva) by megger
In parallel operation time both NGR’s close or not close if both close what will happen
what is the sludge current
what rectifiers is and what are the types of rectifiers?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
How many double suspension hardware fittings are required on a double circuit transmission tower?
What is the formula to calculate the rating of power cable for three phase current.
