the relationship between phase and line voltages in a 3
phase generator is expressed in what formula?
Answers were Sorted based on User's Feedback
Answer / madasamy
Phase volt is phase to neutral voltage. line voltage is phase to phase voltage
ph.volt = line volt/sqrt(3)
always ph. voltage < line volt
Is This Answer Correct ? | 7 Yes | 1 No |
Answer / msivakailash85
phase voltages=square root(3)*line voltages
Is This Answer Correct ? | 6 Yes | 8 No |
Answer / guest
face to face voltages in 3 phaase is known as line voltages
Is This Answer Correct ? | 2 Yes | 5 No |
for 12KW motor which cable size has to select for ex.10 meter.
A shopkeeper allows 10% discount on the price of an article and sells it for Rs 7,600. What is the marked price of the article?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
IN OLTC we observed "OUT OF STEP" Alarm, we have two different transformer, when both are in parallel this type of alarm observed. what's the meaning of this alarm and why it occurs???
What is plc.
We have 2 no. 4MW DG set. and GEB supply. But, we running, only 1 DG set. when we done APFC/Power factor setting : 0.90, then winding temp. Low. but when setting done : 0.83, then Winding temp. increase. WHY Why ? ? ?, plz give me answer.
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
we want install 11KV generator to supply power 12km far from the power house.Load to be fed is 1MW.which conductor should we use and wat will be transmission line losses?
Why is starter necessary for a three-phase induction motor?
37 Answers BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt,
How much RPM in Turbocharger in Diesel engine.
if we are using ACB in a panel the how much clearance do we need in panel room.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage.