Answer / shivendra_sharma1980

Output power is always less than input power because during
conversion of energy some losses occurred (iron loss,
cooper loss)

Answer / atif

we can't do this practically b-coz Motor starting current
is more than running & generator initial voltages are not
enough to start the motor thats why they can not start
directly. In running condition there is fluctuation in
generator posible to stop motor if we start motor using a
second as primover. So it is difficult.

Answer / vijay balu raskar

Generation of electricity is done by using generator. Generator makes electricity as per number of rotations. Higher the number of rotations high will be generation. If we connect motor output the generator then speed of the generator is low as compare with motor and usually output of generator. Motor required high starting current / we can say torque. Hence, we can't.

Answer / amit sharma

Since the motor's output is just to get the Mechanical work
done from Electrical supply, so if connected the same to a
generator, than no need of the Engine of the DG.
Similarly, the DG output is to produce Voltage.The Voltage
produced by a DG is normally given to an AC motor (single
or 3 phase)which is a common practice...

Inductor and capacitor........power in one phase and ...... in it another phase.

0 Answers  

---

In iduction motors the current is higher than normal for both the cases when the voltage appllied is more than the rated as well as less than the rated, why?

2 Answers  

---

how much current will take for 1kw power. and what is the eqoutiion which is connecting with kw and A.

2 Answers  

---

How RTCC panel is working and give single line diagram for RTCC with transformer?

0 Answers   AB Associates,

---

How to calculate battery back up time for a 400 AH battery bank installed in telecom shelter for a load of 20 Amps and time taken to fully charge this battery bank?

3 Answers  

---

Define conversion efficiency of a power amplifier.

0 Answers  

---

how to calculate the ac and dc wire losses with calculations plz tell me

3 Answers   Apollo,

---

Can anyone explain the power flow in flouresent lamps (tube lights) .What are the functions of Starter & choke used there?

1 Answers  

---

what will happen if delta - star , 400V to 6.6KV step up transformer neutral is not grounded, Neutral is not used but transformer is provided with neutral.

2 Answers  

---

When MICC cables used ?

0 Answers   Clinga,

---

what is the role of frequency in electrical system

2 Answers   Hindalco,

---

what are the safety measure & controls in engine?

2 Answers   RRB,

---