Answer / joy banerjee (joysbag@gmail.co

Calculate the Load current by KW = 1.733xVxIx CosQ

Where
- V = Voltage
- I = Current
- CosQ= Power Factor

After getting the Current we can select the cable from the
cable manufacturer's chart or by selecting the current
density(D) and using the formula

Current density = I / A

where
- I = Currrent in Amps
- A = Cross section area in sqmm

What Happen When output Short of transformer

2 Answers   L&T, Saber Corporation,

---

How much allowable difference current between on three phases Dear sir, We have a 1870 KW HT motor, 11 Kv supply,FLA-120A,2870 rpm,2-pole squirrel cage induction Motor.And stator is connected in star connection with Liquid resistance stater to limit the starting current.It has coupled with Centrifugal air compressor.My question is it is loading 73% of FLA taking R-phase 86.7 A, Y-phase-85.4A,B-phase- 78.3A.why the B phase current is that much of difference.Is it allowable, or any one tell me how much allowable current.If any method to calculate.

1 Answers  

---

percetans

0 Answers   Bhel,

---

Why Drives are used to run AC motors?

3 Answers  

---

In what circumstanced the CT used for protection relay will be saturated?and what will happen to the relay is the CT is saturated?

3 Answers  

---

how is the leakage current flow only through guard wire (when guard wire is connected in the circuit)????

2 Answers  

---

In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.

0 Answers   Kaytech,

---

if flux and load static in dc motor and supply voltage increases 20% then what happened in speed

0 Answers  

---

what is ripple component in ac supply?

2 Answers  

---

What is the exact minimum vale of voltage between an earth and netural which can damage or can do malfunction of the electronic equipments ? If this is mentioned in any book, pl.give reference.

0 Answers   Bhushan Power Steel,

---

How do you select a cable size(Cu&Al) for a particular load

10 Answers   Adhunik, BPCL Bharat Petroleum, Hiecon, TATA,

---

Re: What do you mean by Power factor of a generator? Power factor purely depends on the load (wether inductive, reactive or unity) then what does the Power factor mentioned on the generator nameplate means?

2 Answers  

---